Rotation of Local Coordinate for Analysis Drawing Pprocess of Metal Polygonal Section By (Fem)

Saad Theyyab Faris; Jabbar Kasim Jabbar

doi:10.24237/djes.2008.01110

Authors

Saad Theyyab Faris College of Engineering, University of Diyala
Jabbar Kasim Jabbar College of Engineering, University of Diyala

Abstract

The most important activity of metal forming technology is the correct design of stages geometry for economic consideration in order to increase the metals utilization coefficient and the productivity realized products with high dimensional accuracy and a finer quality of worked surface.In this Study the rotation of local coordinate by using finite element method through (M. S. C / Nastran ) are investigating with influencing of some parameters such as , Reduction area , Simi die angle and friction factor to obtain the stresses and strains developed during the drawing process of polygonal section from round section .The results show that its possible to use the technique of rotation of local Coordinate in all programs of ( F.E.M ) to analysis metal forming process especially when the friction factor = 0.1 , Simi die angle = 9, Reduction area =35% which are gives good agreement to the results of ( U.B.T )and the practical results.

Downloads

Download data is not yet available.

References

S. Hoshino "An Upper Bound Solution for the Drawing or Extrusion of Square Section from Round Bar Through Converging Die" Int. J.Mech Tool Design Res. No 21 pp (97 – 107) [1988].

B.B.Basily& D.H.Sansome "Some Theoretical Consideration for the Direct Drawing of Section Rod" Int. J Mech Sci Vol 18 pp (201- 208)University of Astone –England Birmingham [1988].

J.S.Gunasekera "Analysis of Drawing of Polygonal Section Through Straightly Converging Dies" Jernal.Eng.Lnd Trsaction of the ASME Vol 104 PP (38-45)[ 1998].

M. Kivchi "Study on Non Symmetric Extruction and Drawing"University of Tokyo Japan, Inter. Mech Tool Design Res. Conf.No 3 / 22nd pp (523 – 532) [1998].

Timo.Menders"Simulation of Sheet Metal Forming Processes" ph.D Thesis Department of Applied Mechanics Section University of Twente .P .O Canada [1999]

W. K. Jawad "Study the Effect of Die Geometry on Deep Drawing Operation Using Finite Element Method" Ph.D Thesis University of Technology Department of Production & Engineering and Metallurgy / Iraq [2003].

L. Nistor & M.Tintelecan "Modeling of Geometry Design in Wire Drawing Using Cassette Roller Die "Advanced Materials Research. Vol 23 [2007] pp (173 – 178) .

Han .Shen. Wang "Characterization of Severely Deformed Austenite Stainless Steel Wire "National Tawan University, Materials Science and Technology Vol 21 [2005] pp (1323 – 1328) .

Talal. Abdul Jabber Abdul Wahab "Cold drawing for ax Symmetric Section bar "PhD Thesis university of Bradford England [1989].

A.R. Ismail "Investigation of the Effect of Area Reduction Ratio for Various Profiled Direct Extrusions Dies Using (F.E.M) University of Technology Eng. & Journal No 2 / Vol 21 pp (60 – 73) [2002] .