Studying the Strength of the Pile Cap Concrete Simulated as a Continues Deep Beam using Self Compact Concrete

https://doi.org/10.24237/djes.2018.11205

Authors

  • Zouhear A. Hachem Department of Highway and Transporting Engineering, College of Engineering, Al-Mustansiriya University, Iraq

Keywords:

Pile cap, deep beam, shallow beam, depth ratio, self-compacting concrete

Abstract

This paper is an experimental study to investigate the effect of concrete compressivestrength on the structural behavior of continuous reinforced concrete deep beams to utilize the results on the piles caps works. Three nominal concrete compressive strengths 50, 60 and 70 MPa obtained by selfcompacting concrete were frequently used with four groups of shear span-to-depth ratios 5.71, 1.25, 1.08 and 0.95 to produce twelve continuous beams; three of them are shallow and the rest are deep. The comparisons were designed to reveal the variation in thestructural behaviors among the shallow and deep specimens from a side, and among the deep specimen from another side. The experimental program concentrated on the ultimate strength, load -deflection curve, cracking and failure mode of the specimens. The results revealed that the concrete compressive strength is an effective factor on the behavior of the deep beam and when its value increased the ultimate strength and the serviceability of specimen can be improved about 48% whilst the enhancement achieved in shallow beams about 9%. The percentage of the obtained improvement for a specimen can be increased by decreasing its shear span-todepth ratio

Downloads

Download data is not yet available.

References

Adebar P., Kuchma D., and Collins M. P. Strut-And-Tie Models for the Design of Pile Caps: An Experimental Study, ACI Structural Journal, Jan-Feb, 87,(1), (1990), 81-92.

Birrcher D., Tuchscherer R., Huizinga M., Bayrak O., Wood S., and Jirsa J., Strength and Serviceability Design of Reinforced Concrete Deep Beams, Center for Transportation Research, the University of Texas, (2009), 400.

Al-Sarraf S. Z., Al-Shaarbaf I. A. S. and Diab A. S., Effect of Steel Fiber on the Behavior of Deep Beams with and without Web Opening, Eng. & Tech. Journal, 29, (1), (2011), 19.

Singh B., Kaushik S. K., Naveen K. F. and Sharma S., Design of a Continuous Deep Beam Using the Strut and Tie Method, Asian Journal of Civil Engineering (Building And Housing), 7, (5), (2006), 461-477.

ACI Committee 318, Building Code Requirements for Structural Concrete (ACI318-08) and Commentary (ACI318R-08), American Concrete Institute, Farmington Hill, Michigan (2008), 471.

Shahidul Islam S. M., Automated Design of Reinforced Concrete Deep Beams, Ph.D. Thesis, School of Engineering and Information Technology, University of New South Wales, Canberra, 2012, 285.

Seo, S. Y., Yoon S. J. and Lee W. J., Structural Behavior of RC Deep Beam with Headed Longitudinal Reinforcements, 13th World Conference on Earthquake Engineering Vancouver, B.C., Canada, (58), August 1-6, 2004, 12.

Nagarajan P., and Pillai M. T. M., Development of Strut and Tie Models for Simply Supported Deep Beams Using Topology Optimization, Songklanakarin Journal of Science and Technology, 30, (5), Sep. – Oct. (2008), 641-647.

Campion, J. M., and Jost, P., Self-Compacting Concrete: Expanding the Possibility of Concrete Design and Placement, ACI Concrete International, 22, (4), April 2000, 31-34.

ASTM Designation C494–86, Chemical Admixtures for Concrete, Annual Book of ASTM Standards 1989, 04, (2), 248–255.

Aguilar G., Matamoros A. B., Parra-Montesinos G. J., Ramírez Julio A. and Wight J. K., Experimental Evaluation of Design Procedures for Shear Strength of Deep RC Beams, ACI Structural Journal, 99, (4), Jul-Aug. (2002), 539-548.

Roy N. C. and Breña S. F., Behavior of Deep Beams with Short Longitudinal Bar Anchorages, ACI Structural Journal, 105, (4), Jul-Aug. (2008), 460-470.

Arabzadeh A., Aghayari R. and Rahai A. R., Investigation of Experimental and Analytical Shear Strength of Reinforced Concrete Deep Beams, International Journal of Civil Engineering, 9, (3), Sep. (2011), 207-214.

Quintero-Febres C. G., Parra-Montesinos G. and Wight J. K., Strength of Struts in Deep Concrete Members Designed Using Strut-and-Tie Method, ACI Structural Journal, 103, (4), Jul-Aug. (2006), 577-586.

Published

2018-06-01

How to Cite

[1]
Z. A. Hachem, “Studying the Strength of the Pile Cap Concrete Simulated as a Continues Deep Beam using Self Compact Concrete”, DJES, vol. 11, no. 2, pp. 42–48, Jun. 2018.